I’m glad that it’s been switched back to FreeBSD. I’ve had a lot of problems out of TrueOS & it’s derivatives, every since it became a bleeding edge OS.

Installation CD cannot start installation program because of X11 failure. Xorg.0.log reports that no devices nor screens are found. This problem is also present on the TrueOS 18.06 installation disk. There's an issue with the nvidia driver. From what I can tell, the drivers included on the installat...

Looks like I was mistaken on the available nvidia driver versions.

Release - 415.27
Beta - 418.30

I can't give this output for one of my systems, since there doesn't seem to be a pkg for the required driver. I had to swap hard drives with another system in order to do the OS installation, & X11 won't even run. However, I can tell you specifically about the gpus that it's running & which ...

I found the problem. Apparently, the command listed in the menu ".../bin/gsmartcontrol-root" should instead be ".../sbin/gsmartcontrol".

While trying to run GSmartControl after a fresh installation of GhostBSD 18.10, I continue to receive a GTK warning that results in the program not being able to run. GSmartControl was not included by default in past releases of GhostBSD, but it is now included. Even in past versions, I've had the s...

pciconf -lv | grep -B 4 VGA vgapci0@pci0:132:0:0: class=0x030000 card=0xc8613842 chip=0x062210de rev=0xa1 hdr=0x00 vendor = 'NVIDIA Corporation' device = 'G94 [GeForce 9600 GT]' class = display subclass = VGA cat /etc/X11/xorg.conf | grep Driver Driver "nvidia"